• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

10mm

  1. R

    Kitless in Red Mallee Burr

    I nice piece of Mallee burr from Phil to make this one. Size 5 Bock nib. I went with a 12mm cap thread on this one to give it a go with 10mm section thread. I will be going for a slimmer version next time as my confidence grows.
  2. F

    TM Athena

    Hi All, Can't go anywhere today unless it's on skis so I thought I would make this. First time I have made a button push pen. It went together very well. The instructions say use a 25/64 twist bit but a 10mm bit works just as well. Lovely kit from TM.:thumbs: Cheers Frederik
  3. webby962

    Bench Drill Press - Question

    Gents, I know this topic has been covered before, and everyone has their own preference, but I am after some specific advice. I currently use my lathe for drilling my blanks and other than the faf of moving the tail stock every few cm, it does a reasonably good job, but on sizes above 10mm, I...
Top