• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

18475

  1. qquake2k

    Homemade Carbide Handle

    I bought some 15mm carbide radius cutters from Arizona Carbide a while back, and finally got around to making a handle. I used a 12" length of mild 1/2" square steel. I marked it, drilled it, and tapped it with an 8-32 tap. For the notch, I cut a slot with a hacksaw a little deeper than the...
    • qquake2k
    • Thread
    • 18475 carbide cut handle mdn notch tap
    • Replies: 24
    • Forum: Turning Pens
Top