antler

For my grandson that I left in their raw state from a small piece of shed Whitetail antler that he found. Les

I found an antler while clearing the undergrowth beside the garage and reckon it to be over 60 years old. Pen kit is a Beaufort Sirocco.

Antler on a SS 2 piece core. Finished antler with 10 coats of Thin CA. Polish outside and inside core 220 thru 2500 grit. Finish polished with AUTOSOL Les

Gun Metal Bolt Action with Elk antler marrow with a SS Two Piece Core Size 8.5 X 6mm Wide Elk antler marrow with a bit of bark. Stabilized with BSI Thin CA and finished with several coats of BSI Medium CA.. Polished with AUTOSOL metal polish. Les

Some future SS One Piece Core's to be dressed up with 2 Elk antler marrow blanks and one Deer antler marrow blank. Les

With my Elk Antler Bolt Action pens. Size 11 X 8mm SS One Piece Core with a piece of Elk Antler marrow with a bit of bark. Finished with many coats of Thin CA to fill the marrow pores. Les

I do .308 bullet pens and a guy that bought 2 asked if I could make one from his .243 cases, I knew the slimline would need some jiggling about as the 7 mm tube wont fit through the .243 or 6mm, the guy sent me some antler as I had suggested he send me a case and antler from a stalking trip he...

The little girl next door found a shed antler earlier in the spring and asked if I would make a pen for her. I really liked the copper Sirocco with the antler. She is a happy little girl!

This was supposed to be for me but I don't like it so will probably sell it on where I go to fish. Specifically I think the tiger bamboo is too fussy on a kit with that much detail and maybe should be a much plainer wood or even antler or horn. I'm not sure I like the kit either but being a keen...

To keep Phil happy, here is a Jr G II in deer antler and natural crushed turquoise. I don't use every parts of a kit so often...

Hi all, anyone know where i can get some antler blanks?? or is it just a case of buying whole bits from fleebay??:thinks:

Not made a stick for a while so this was a pleasant diversion. Points cut off the antler and replaced with African Blackwood, domed to prevent injury. Shaft is hazel with a solid nickel collar to hide the joint as it's impossible to get an exact cross section match with antler. Could someone...

A very DEER :winking: chrome Safety razor made using a naturally shed Deer Antler.

I was wanting to get some of the natural bark left in places but the antler was a bit to thick, managed it on the 3rd one in the center.

My Daughter and Granddaughter came this weekend and I only managed to get this done and not the Tempest as I thought, so maybe during the week now for the Tempest. I drilled the antler with an offset which ideally could have been more offset, so I kept it chunky to show more of the natural bark...