• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

disk

  1. Penpal

    Blank prep

    I marvel at the certainty when using this device I cobbled up using my dedicated 12 inch Disk Sander. Last blank was Plastic now to clean the disk. Dust all over the trimmed blanks and they are ready to rim ream the brass now. These three destined for this or next week. Many people use this...
    • Penpal
    • Thread
    • blank destined disk ream set
    • Replies: 5
    • Forum: Off Topic
  2. Penpal

    Replacing the 12 inch sanding disk

    One task I put off, dreading the stripping to achieve this result I gave it a go cutting off half of the old disk, the pulling off from the Velcro the other half. A light brushing then no way was the gap sufficent to let the new disk through. So I went to a roll of Jack Paper I had bought in...
Top