• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

edges

  1. alan morrison

    Celtic knot

    I wanted to try a knot with 5 layers of veneer. Changed the glue so the edges are a bit cleaner.
  2. flexi

    New to me!

    Hi all, Well this was a new take on an old trick....I had some laser engraving done on two separate pens, customer's names. It was very nicely done but a little deep( tube just showing) so I thought about an infill. I have never used Milliput before, but certainly will again.....very easy to...
    • flexi
    • Thread
    • edges engraving lasers scorch tend
    • Replies: 12
    • Forum: Turning Pens
  3. BradG

    Conical segments, kitless Aluminium fountain pen

    Todays handmade fine writing instrument. Carrying on with the seamless look, a conical design crafted from aluminium. lots of sanding was required to ensure there were no rough edges, without going to the point of rounding off the edges to keep it's sharp appearance. feels lovely in the hand...
  4. Dalboy

    Fowl time

    I thought it was about time I started something. Pretty pleased how close I got all the pieces straight of the saw next job is to sand and get a better fit. Also sand and roundover the edges. I will post more pics as and when I do a little more.
Top