• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

eventually

  1. S

    Got around to a bowl eventually

    Eventually finished turning seam rippers and pens that people asked for, so have now got around to having a go at a maple bowl.
  2. Dalboy

    First day in the workshop

    Well, have spent the first day in the workshop hoping to at least get something made. And what do I end up doing crawling around the floor cleaning under every unit in there dropped a screw from an expensive caliper set, not the easiest thing to replace:vangry::vangry::vangry:. Eventually...
    • Dalboy
    • Thread
    • day eventually replacevangryvangryvangry thing workshop
    • Replies: 18
    • Forum: Off Topic
  3. P

    New Pot, eventually!

    Eventually got a pot sorted for pressure casting. Now to work out the needed fixtures and fittings and try out the benefits of casting under pressure! Oh and find a nice quiet compressor!
    • pb88
    • Thread
    • eventually find pot pressure slimline
    • Replies: 3
    • Forum: Casting
  4. Dalboy

    A terrible day

    I feel absolutely knackered today. Got woken at 2:30am with terrible cramp in both feet followed by a tightness of the chest, wife phoned 111 and next thing ambulance sitting outside front door. They seemed to be here ages. A 1/2hour later in hospital for the next 6 hours in and out of little...
    • Dalboy
    • Thread
    • eventually home hospital knackered sitting
    • Replies: 10
    • Forum: Off Topic
  5. woodhacker

    stick top

    Haven't been doing much turning lately but I have made this. Horns are fashioned from deer antler and the wings from rams horn. It will be mounted on a hazel shaft eventually. Forgot to mention its 7 1/2" from base to horn tip. Yes I work in Imperial. :tongue:
Top