• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

jammed

  1. hawkeyefxr

    Lathe problem

    I was working on my Record DML305 lathe today using a 3 wheel steady as the work piece was about 8/9 inches long. I stopped the lathe to adjust the dust hood, on starting it again for a fraction of a second i noticed the work piece did not move then the was a clack and it ran. Later i found out...
Top