• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

lasers

  1. flexi

    New to me!

    Hi all, Well this was a new take on an old trick....I had some laser engraving done on two separate pens, customer's names. It was very nicely done but a little deep( tube just showing) so I thought about an infill. I have never used Milliput before, but certainly will again.....very easy to...
    • flexi
    • Thread
    • edges engraving lasers scorch tend
    • Replies: 12
    • Forum: Turning Pens
Top