list

As you know i have just started making pens again after a few years. I have various bushing for pens but don't know what pens they are for. Is there a list of bushings and their sizes, i know there are all different pen sizes but the brass tube stays the same for all pens.

Hi Everyone, I'd like to start turning some small parts from wood; the parts are just wooden tubes similar to pen shafts. The maximum length will be 10cm and the interior diameter will always be the same. I'm putting together a minimal tools list and I was hoping you could check & advise on...

As a gadget freak and toolaholic i frequently find sites that interest me then forget where I put them!! this one popped up from a very old favourites list that I just found, it might interest some of you. Engineering Tools, Engineering Supplies lathe and workshop tools

This is my first attempt at an Omega, really nice kit. A Tempest from Beaufort is next on my list to try. Pat

Anyone hoping that Santa brings something exciting for the workshop? What's on your list? Me? A bit more heating in my workshop would be nice right now. It's not got above minus 5 outside for a week now!

Placed myself back on deck again with so many times outside to enjoy at last. Off the list of endangered species is a pleasure. Peter.

Been on my list for a long time and I admit to struggling a bit to finish it, my boredom threshhold is low and the sanding was a bit tedious so don't know if I'll do it again though the kids say I have to so there's no fighting when I pop my clogs :funny: Wood is some kind of softwood I think...

Don't laugh...:funny: Some may remember this post.. http://www.penturners.co.uk/off-topic-forum/11692-well-im-list.html Well I am on the list again.... Multi level spinal fusion :sob:..:rolling: :funny: Well I never, first they say yes, then they say no, then they say yes.... sounds like...