• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

pipe

  1. fingwe

    Mould release for PVC pipe

    Hi everyone, I want to start casting my blanks in pvc pipe so they are round, but I’m having terrible trouble getting them out of the pipe. I’m having to cut it off each time. What’s the best mould release to use for alumilite? I’ve tried a couple of silicone sprays but they’ve made no...
    • fingwe
    • Thread
    • difference mould pipe pvc
    • Replies: 21
    • Forum: Casting
  2. P

    Latest Santa

    Here is my latest Santa for a work colleague. Still not happy with the eyes, but they are getting there. Thought the pipe gives him a chilled out look. He'll need it after Christmas Remove
  3. Gizmo3k

    My first cast

    Please excuse the picture quality, didn't have time to get the light box out. This is my first attempt at casting, using waterclear Products and metallic mica powders. It was poured into a bit of pvc pipe, and came out with a little persuasion! This will be my first delta once it is done...
    • Gizmo3k
    • Thread
    • bit cast pipe poured pvc
    • Replies: 7
    • Forum: Casting
Top