• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

slot

  1. wm460

    .50 Cal Bottle Openers

    Just wondering if any one has made a .50 Cal Bottle Opener. I would like to know what angle and how deep do you cut the slot into the case? .50 Cal cases are too hard to get here , to stuff one up in trial and error.:goesred:
    • wm460
    • Thread
    • bottle cal case cases slot
    • Replies: 4
    • Forum: Turning Pens
  2. Doug

    Glasses stand

    The secretary of the local woodturning club asked if I could turn some glasses stands for their charity stall, I was handed a piece of paper with the design on & this is my first attempt, apparently they sell extremely well. So first up a little spindle moulding Followed by some routing...
Top