• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

teeth

  1. J

    Drill press table - ideas?

    Hi everyone I have a bench mounted drill press which I use a lot. It's the type that has a post without the 'teeth' on it , therefore adjustment has to be made via the clamp. I've always found this quite difficult but having had a recent accident with my right hand, it's become more of a...
  2. hawkeyefxr

    Steb Drives

    I though i would look into getting a Steb Drive, i chose this one below as i liked the price £11.00, Inc VAT & Delivery! I have not tried it yet but i plan to tomorrow, what i can say is those sharks teeth are damn sharp! i may well get the tailstock one as well as it is only a 1/2 inch diameter.
  3. webby962

    Imperial drill bits

    Quick question peeps :-) I'm think of having a bash at the TM Omegas, but wondered where to get the 15/32" and 25/64" drill bits from (of a decent quality too). They seem to be like hens teeth! Any ideas to save me from hours of googling? Adie
Top