• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

voids

  1. flexi

    Corn cob

    Hi all, Quite pleased with this one.... Dyed and stabalised, but still found voids so out with the CA:whistling:
  2. silver

    Bullet in Popular burr

    Kit - Gun metal Bullet Blank - Popular burr wood. Finish - CA to fill all voids and then Melamine finish.
  3. Bammer

    Sea Shell pens and how I did it

    Seashells cast in dyed Epoxy on TM Sigma's I shall try to explain the difficulties in turning these pens after you seen the photo's 1st off, I didn't really want to make these but a good customer requested one, so he bought 2 .. The shells are incredibly hard and will blunt an HSS tool...
  4. D

    TM Epsilon Gunmetal

    This came off the lathe second today, first time with this kit and first time with a wood/acrylic blank needed to fill a couple of voids with ca again a first but very happy with result.
  5. Bammer

    Sirocco with Oak Burr and Ali

    Got this piece over a year ago from Geordie, unlike him it was hard as nails. The voids were not visible before I started playing with it but pleased they were there in the end. Filled with Ali.
  6. Bammer

    Burr Oak with Ali inlay on an Alpha

    Lots of voids in this bit :love_it: Brad
Top