New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Well done, Tony. I like the way you corrected your mistake on the first pen.

Your Unimat should not prove much of restriction. The Sherline lathe I use is of a similar size and I make all kinds of pens on it. As others have said, you just need the right bushes for the pen you are making.

[QUOTE="Bob Ellis, post: 212437, member: 782"] Well done, Tony. I like the way you corrected your mistake on the first pen. Your Unimat should not prove much of restriction. The Sherline lathe I use is of a similar size and I make all kinds of pens on it. As others have said, you just need the right bushes for the pen you are making. [/QUOTE]

Verification