• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Yes bog standard Phil. I just make them slightly longer than the tube and mount them on the mandrel the same as normal.  Turn the top down to the diameter  you want ( I don't every measure anything as it adds to the uniqueness) and then turn the bottom half to slightly less, I guess about an 1/8th.  Turn the top where the clip button goes over at the corner and slightly where the top meets the bottom and then the nib end down to the correct diameter for the normal slimline to the bushing.  Job done.


Top