• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Jim and Terry


I bought a pen mill to square the ends off and thought the centre bit is supposed to clean out the inside of the tube. Do they not do this proberly? I have some round needle files so no problem using these also if necessary.


Bob


Top