• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Another tip When I drill acrylic I always cut them to long and dont exit with the drill especially on round blanks just measure the tube on the drill bit and put a bit of tape on the drill as a stopping point then cut the excess off after good luck


Top