New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I usually finish acrylics by polishing through to 12000 grit Micromesh and a final coat of Hut Ultra Gloss Plastic Polish, but since several people on this thread have extolled the superior virtues of Frécla, I thought I would try it. I ordered some Farécla 300 and 500, which arrived yesterday. The 300 seems to be the right stuff - it says Farécla Profile 300 Rapid Cut on the bottle - but I'm not sure about the 500. Although it said 500 on the website, there is no mention of 500 on the bottle, which is labelled Farécla G10 Finishing Compound. Is this the right stuff?

There are no directions on either bottle about how to use it, so any tips would be much appreciated.

[QUOTE="Bob Ellis, post: 227166, member: 782"] I usually finish acrylics by polishing through to 12000 grit Micromesh and a final coat of Hut Ultra Gloss Plastic Polish, but since several people on this thread have extolled the superior virtues of Frécla, I thought I would try it. I ordered some Farécla 300 and 500, which arrived yesterday. The 300 seems to be the right stuff - it says Farécla Profile 300 Rapid Cut on the bottle - but I'm not sure about the 500. Although it said 500 on the website, there is no mention of 500 on the bottle, which is labelled Farécla G10 Finishing Compound. Is this the right stuff? There are no directions on either bottle about how to use it, so any tips would be much appreciated. [/QUOTE]

Verification