New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Ray has given sound advice, as usual. If these checks don't cure the problem then have a look to ensure that the cartridge piercers are in place. Of course they should be, but maybe there was a cock-up at the factory and a batch has gone out with a defect in them. Most likely fault will be that the inks in the cartridges have dried, and Ray has covered that.

Bob.

[QUOTE="bluntchisel, post: 219753, member: 249"] Ray has given sound advice, as usual. If these checks don't cure the problem then have a look to ensure that the cartridge piercers are in place. Of course they should be, but maybe there was a cock-up at the factory and a batch has gone out with a defect in them. Most likely fault will be that the inks in the cartridges have dried, and Ray has covered that. Bob. [/QUOTE]

Verification