New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Do any of you guys use Aluminium strips or whatever in pen making?

I have found a few ally bits that were left in my Bin a couple of years ago by fitters that did our Solar Panels and i was thinking that i would cut em up and save some of the good usable bits into strips, any advise as to the best way to do it would help! this is the pics of one of them!

[ATTACH]6693[/ATTACH]
[ATTACH]6694[/ATTACH]
[ATTACH]6695[/ATTACH]

It is just under 2mm Thick!

[QUOTE="bassethound, post: 68096, member: 440"] Do any of you guys use Aluminium strips or whatever in pen making? I have found a few ally bits that were left in my Bin a couple of years ago by fitters that did our Solar Panels and i was thinking that i would cut em up and save some of the good usable bits into strips, any advise as to the best way to do it would help! this is the pics of one of them! [ATTACH]6693._xfImport[/ATTACH] [ATTACH]6694._xfImport[/ATTACH] [ATTACH]6695._xfImport[/ATTACH] It is just under 2mm Thick! [/QUOTE]

Verification