New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I have used epoxy and CA, what you have to be careful of is the heat which will make both of those fail if it gets too much, just take it slow and keep feeling the aluminium if it is too hot for your fingers it will fail and you will get blisters if it is just about to fail

Peter

[QUOTE="Buckeye, post: 68121, member: 294"] I have used epoxy and CA, what you have to be careful of is the heat which will make both of those fail if it gets too much, just take it slow and keep feeling the aluminium if it is too hot for your fingers it will fail and you will get blisters if it is just about to fail:funny: Peter [/QUOTE]

Verification