New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I have that to but it only shows the external and you need a metal turning lathe with threading gears to make it work.
I have that and did do one but wouldn't go back for another, maybe if I had the cnc I have now it may be easier and the ability to save the settings which I didn't have then.
Once again I would not set that up for nothing less than a large production run

[QUOTE="Grump, post: 156723, member: 232"] I have that to but it only shows the external and you need a metal turning lathe with threading gears to make it work. I have that and did do one but wouldn't go back for another, maybe if I had the cnc I have now it may be easier and the ability to save the settings which I didn't have then. Once again I would not set that up for nothing less than a large production run [/QUOTE]

Verification