• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Another blue line

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
The support for the services are most needed right now,we all call on them expect them to put their lives on hold and in jeopardy for us. Great sybols mate.

Peter.
 

fortress

Registered
Joined
Apr 11, 2016
Posts
5,178
Location
Astley
First Name
John
Another nice pen Angelo, did you download, size then print the image onto decal paper?
 

flexi

Executive Member
Joined
Sep 12, 2014
Posts
6,454
Location
Maidstone
First Name
mark
Oooh that's nice....I like the subdued look.... sometimes they become too busy.....but that's nice:drool::drool:
 

angelo49

Registered
Joined
Jun 19, 2013
Posts
2,827
Location
Lancaster, PA Brooklyn, NY USA
First Name
Angelo
Another nice pen Angelo, did you download, size then print the image onto decal paper?

John,
I got the photo on line. I use the ancient photo editor Picture It 7 (202)
No BS editor!
I figure the Circumference based on the dia. of the finished blank
C=pi. ( 3.1416 ) x's the diameter of the finished blank = the width of the decal.
I the round that up to the nearest fraction. Then print the decal.
When I apply the decal it overlaps and I very carefully razor cut the overlap line
and remove the thin sliver of decal.
This gives you a perfect butt joint which I myself sometimes cannot find!
BUT........... I print a few of these because the first attempt isn't always sucessful.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top