New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Been busy in the shed today. Turned two pens and one bowl.

Here is the first offering. Wych Elm on an Axminster Americana kit.

[ATTACH]5923[/ATTACH]

Main issue I have with this is that I didn't notice until I finished the pen that the botton tume is 2.5mm shorter than it should be. This means the pen doesn't retract fully and comes out way too far. I will be taknig it and a good one to Axminster on Saturday for a rant

[QUOTE="chas_41_uk, post: 60896, member: 441"] Been busy in the shed today. Turned two pens and one bowl. Here is the first offering. Wych Elm on an Axminster Americana kit. [ATTACH]5923._xfImport[/ATTACH] Main issue I have with this is that I didn't notice until I finished the pen that the botton tume is 2.5mm shorter than it should be. This means the pen doesn't retract fully and comes out way too far. I will be taknig it and a good one to Axminster on Saturday for a rant :rant: [/QUOTE]

Verification