New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I really hope so Peter. Cutting little brass billets from 5mm diameter bar would work but I reckon I will have to replace the fixed screw on the opposite side of the blade as well with something similar. If I could source replacement blade holders I can make it a project.
I had a good day today with the machine and it should do as learner machine.

[QUOTE="donwatson, post: 239726, member: 503"] I really hope so Peter. Cutting little brass billets from 5mm diameter bar would work but I reckon I will have to replace the fixed screw on the opposite side of the blade as well with something similar. If I could source replacement blade holders I can make it a project. I had a good day today with the machine and it should do as learner machine. [/QUOTE]

Verification