• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

A quick update to this saga. I have given the table a rub down to 600 grit and the wood slides a lot easier. I have made a zero clearance plate and it works well.

When you tighten the grub screw it bends the blade, I will need to make some loose brass slugs for securing the blade.

Otherwise I am finished with fettling and ready to do some serious work. :whistling:


Top