New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I had the same problem, and like others here a new blade cured it . I was told that once a bandsaw blade has been used to cut a curve it will never cut straight again, I don't know if this is just an old wives tale but have 2 blades one for cutting curves one for straight cuts and everything runs fine ... I do tune my blades before use as well

Good luck

[QUOTE="Tephy, post: 169579, member: 672"] I had the same problem, and like others here a new blade cured it . I was told that once a bandsaw blade has been used to cut a curve it will never cut straight again, I don't know if this is just an old wives tale but have 2 blades one for cutting curves one for straight cuts and everything runs fine ... I do tune my blades before use as well Good luck [/QUOTE]

Verification