New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Jim,
I have had a look at the manual to refresh my memory.
[ATTACH]17221[/ATTACH]
Unlock the cap screw H, and move the bearing and shaft backwards out the road.
Unlock the cap screws C and move the guide pins to the sides, out the road.
Unlock the cap screw E and move the guide black backwards out the road.
This should clear all the obstacles on the top and the blade should run freely.
This should only take a couple of minutes and gives me time to create the second bit of the set up.

take care
Don W

[QUOTE="donwatson, post: 169624, member: 503"] Jim, I have had a look at the manual to refresh my memory. [ATTACH]17221._xfImport[/ATTACH] Unlock the cap screw H, and move the bearing and shaft backwards out the road. Unlock the cap screws C and move the guide pins to the sides, out the road. Unlock the cap screw E and move the guide black backwards out the road. This should clear all the obstacles on the top and the blade should run freely. This should only take a couple of minutes and gives me time to create the second bit of the set up. take care Don W [/QUOTE]

Verification