-
Thanks for visiting The Penturners Forum today.
There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.
To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.
Band saw
- Thread starter glenpen
- Start date
The make is PERFORMANCE POWER from B & Q ( NU TOOLS ? )
Glen
Try these people Free Saw User Manuals | ManualsOnline.com
This is De ja voo init?
I seem to remember this question before, surely the answer is still the same??
http://www.penturners.co.uk/off-topic-forum/4941-manual-reqd.html
Unless this is it rebadged,
http://dl.owneriq.net/2/25b2d6bf-98ca-40b7-9028-799685051d70.pdf
I seem to remember this question before, surely the answer is still the same??
http://www.penturners.co.uk/off-topic-forum/4941-manual-reqd.html
Unless this is it rebadged,
http://dl.owneriq.net/2/25b2d6bf-98ca-40b7-9028-799685051d70.pdf
DEAD RIGHT, Still looking, Thought there may be a new members to the forum with the manual.
Perhaps some one could tell me how to change the Drive Belt or perhaps the instructions will come with the new belt I am getting. Well I can hope
1 Remove the phillips head screws from the belt cover and
remove belt cover. Set it aside.
2 Remove the cap bolts from the bottom of the motor
housing using a hex key wrench.
3 Remove the top motor cap bolt while supporting the
motor.
4 Pull the motor away from the band saw and slide the
worn drive belt off of the pulley and discard.
5 Place new drive belt on motor pulley and slide drive belt
over pulley while mounting the motor.
6 Insert top cap bolt through motor housing and thread into
band saw. Finger tighten.
7 Insert the remaining cap bolts into the adjusting slots and
thread into band saw.
8 Rotate the motor anticlockwise to tension the new
drive belt and tighten the cap bolts.
9 Replace the belt cover and attach with two philips head
screws.
remove belt cover. Set it aside.
2 Remove the cap bolts from the bottom of the motor
housing using a hex key wrench.
3 Remove the top motor cap bolt while supporting the
motor.
4 Pull the motor away from the band saw and slide the
worn drive belt off of the pulley and discard.
5 Place new drive belt on motor pulley and slide drive belt
over pulley while mounting the motor.
6 Insert top cap bolt through motor housing and thread into
band saw. Finger tighten.
7 Insert the remaining cap bolts into the adjusting slots and
thread into band saw.
8 Rotate the motor anticlockwise to tension the new
drive belt and tighten the cap bolts.
9 Replace the belt cover and attach with two philips head
screws.
Walter
Fellow
perhaps the instructions will come with the new belt I am getting. Well I can hope
Which region of La La land do you live in?
Penpal
Grand Master
Glen all Band Saws are assembled a good reference for aligning and installing drive belts abound wish you well in your quest.
Peter.
Peter.