• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

You can get standard pen mills up to 37/64, there about 10 tube diameters as standard. I use disc sander for all but 7mm tubes as I find the 7mm drill bits wander a little and can make the tube a little out of plumb.


Top