• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

i like to leave a bit of room on the blank incase it is not square at end

i have sharpened on flats but the trimmer is chewing a bit on the blank

and sometimes decides to burr over the tube if i go that bit too far..noobie error

it just wont take a sharpen

p.s. i am using a diamond plate & and can sharpen a chisel u could shave with


Steve


Top