New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Up to you but wouldn't go to that expense unless I needed it for other things plus that will take time to sort out.
Screw a plank of wood to a facelplate and turn it down to round then stick some scratch on it build the jig on your lathe.
Use transfer punches or drill bits of the near right size and you don it all for free or cheap in just a few minutes init?

[QUOTE="Grump, post: 183663, member: 232"] Up to you but wouldn't go to that expense unless I needed it for other things plus that will take time to sort out. Screw a plank of wood to a facelplate and turn it down to round then stick some scratch on it build the jig on your lathe. Use transfer punches or drill bits of the near right size and you don it all for free or cheap in just a few minutes init? [/QUOTE]

Verification