• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Welcome to the forum Phil. I am closer than Dundee, but still a bit far away. I am sure someone closer will be able to help.


I agree with George, the new colleted chuck from Rotur is a good choice. Make sure you get one with the correct Morse Taper for your lathe.


Top