• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

I make my own, I use one of these RDGTOOLS 2MT SOFT STUB ARBOUR BLANK END FOR LATHE 28MM X 30MM MYFORD | eBay


drill the hole through for your mandrel and 4 grub screw holes around the outside,the mandrels themselves I used silver steel,centre drilled and threaded one end.


For tools,you could buy individually, I bought a set of about 8 but only use 4, a parting tool,skew,scraper and spindle gouge.


Top