New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Or use a Jacobs chuck in your wood lathe to drill the bushes, use your drill press or a vice and hand drill with a square you can be as near accurate init?
You don't need a metal turning lathe for a few bushes.
Bushes don't have to be metal either, it don't always gotta cost megabucks, leave the fancy stuff for those who like to waste their hard earned init?

[QUOTE="Grump, post: 237690, member: 232"] Or use a Jacobs chuck in your wood lathe to drill the bushes, use your drill press or a vice and hand drill with a square you can be as near accurate init? You don't need a metal turning lathe for a few bushes. Bushes don't have to be metal either, it don't always gotta cost megabucks, leave the fancy stuff for those who like to waste their hard earned init? [/QUOTE]

Verification