New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Before this gets out of hand we are talking about wood lathes and centers.
Not metal lathes or bearings or ways or tailstocks.
Pure lunacy to put grease or oils in a revolving or dead center but there are plenty of lunatics here that may want to try it init?
Go ahead, try it and see what it does to your wood and workshop and you.
Some people can't be helped init?
And others just jump in when they don't got a clue what they are talking about.
Try reading the thread before gobbing off.

[QUOTE="Grump, post: 239361, member: 232"] Before this gets out of hand we are talking about wood lathes and centers. Not metal lathes or bearings or ways or tailstocks. Pure lunacy to put grease or oils in a revolving or dead center but there are plenty of lunatics here that may want to try it init? Go ahead, try it and see what it does to your wood and workshop and you. Some people can't be helped init? And others just jump in when they don't got a clue what they are talking about. Try reading the thread before gobbing off. [/QUOTE]

Verification