New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

You have a lathe, you have a disc sander! Turn a disc, make sure it is dead flat That takes a velcro pad. Make a table that fits into the banjo and hey presto. I have a disc sander so never needed t do this bit I am sure that soomeone on this forum will have done so and may have photos to post.

[QUOTE="Neil, post: 26252, member: 120"] You have a lathe, you have a disc sander! Turn a disc, make sure it is dead flat That takes a velcro pad. Make a table that fits into the banjo and hey presto. I have a disc sander so never needed t do this bit I am sure that soomeone on this forum will have done so and may have photos to post. [/QUOTE]

Verification