• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

To use transfers just add a few coats of CA, and the last few pads of the micro-mesh Harry, once the transfer is on let it dry then use the CA finish .. If you are getting lumps from the CA finish you may be running to slow. I run the lathe at 1500rpm and as Twister says run the pad along the blank at a good speed this should give you the finish you are looking for .. :thumbs:


Top