New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

As per Jim, but Neil has a point..

Another way is to use cone bushes rather than the standard shaped bushes. That way it won't effect you when you remove the bushes.

I always run the end around on a piece of 1200 W&D by hand prior to building it up to make sure the ends are finished and any residues are equal.

[QUOTE="silver, post: 187802, member: 165"] As per Jim, but Neil has a point.. Another way is to use cone bushes rather than the standard shaped bushes. That way it won't effect you when you remove the bushes. I always run the end around on a piece of 1200 W&D by hand prior to building it up to make sure the ends are finished and any residues are equal. [/QUOTE]

Verification