• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

i used to spray motorcycle tanks and fairings , and always used G3 , for a final polish , good stuff used with a bit of water and a polishing mop , i can achieve a nice finish on the pens its just the access ca on the ends causing the probl3m


as a few people have said i'm most likely using too much   hence the question about using sanding sealer to seal the grain first , then ca used sparingly ?


Top