New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I made my own tools from the handles from small prybars. I just cut off the ends of the pry bar, and ground a notch in it, then tapped it for the screw. I made three of them. I keep a round cutter in one, a square cutter for wood or acrylic in another, and a square cutter for inlayed stone in the third.

[QUOTE="sbwertz, post: 29175, member: 172"] I made my own tools from the handles from small prybars. I just cut off the ends of the pry bar, and ground a notch in it, then tapped it for the screw. I made three of them. I keep a round cutter in one, a square cutter for wood or acrylic in another, and a square cutter for inlayed stone in the third. [/QUOTE]

Verification