New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Hi, Guys,

Have been given some Axminster vouchers to spend on tools. As I can't sharpen a chisel to save my life I thought Id buy one that uses those square, round and triangular carbide tips (I can bin them once blunted). Can't see them on my Axminster site so don't know if they even stock them yet. And another thought occurred to me - with Axminster's go-it-alone attitude when it comes to sizing will bits by other suppliers even fit them?
I welcome any suggestions, chaps!

Bob.

[QUOTE="bluntchisel, post: 235476, member: 249"] Hi, Guys, Have been given some Axminster vouchers to spend on tools. As I can't sharpen a chisel to save my life I thought Id buy one that uses those square, round and triangular carbide tips (I can bin them once blunted). Can't see them on my Axminster site so don't know if they even stock them yet. And another thought occurred to me - with Axminster's go-it-alone attitude when it comes to sizing will bits by other suppliers even fit them? I welcome any suggestions, chaps! Bob. [/QUOTE]

Verification