New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

No problem Miles.

Just a question, why are you using the table rather than using a mitre fence? Would be easier for a fence and can get it to any angle you want up to 90degrees.

The band saw is good, would be an easier cut and smoother if you use a mitre fence and make an even better one with a jig.

If you need anything then you can pm me and can talk it over, sometimes easier to talk it over.

[QUOTE="silver, post: 277319, member: 165"] No problem Miles. Just a question, why are you using the table rather than using a mitre fence? Would be easier for a fence and can get it to any angle you want up to 90degrees. The band saw is good, would be an easier cut and smoother if you use a mitre fence and make an even better one with a jig. If you need anything then you can pm me and can talk it over, sometimes easier to talk it over. [/QUOTE]

Verification