• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Cleaning addition for coke can and similar

Pops92

Pops92

Full Member
Joined
Jun 10, 2020
Posts
66
Location
Boston Lincolnshire
First Name
Richard
I know many dont like using coke cans or similar because of adhesion problems. I use it a reasonable amount and dont suffer much of a problem.
I use 3m roloc bristle disc the green one. Cut the top and bottom off get it flat and in less than 3 minutes ( timed) the can is completely cleaned on both sides as shown. I then wipe the crap off with methylated spirit.
The 3m roloc bristle disc is brilliant for many other as well, great on piston heads.20200703_134338.jpgScreenshot_20200704-231244_Video Player.jpg
 
flexi

flexi

Executive Member
Joined
Sep 12, 2014
Posts
6,457
Location
Maidstone
First Name
mark
Very good idea.....you probably get good adhesion because of the swirl marks left in the ali....others I have seen clean and degrease the ali but then try to stick to a polished surface.:thumbs::thumbs:
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top