New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Found it difficult to buy cross cut but well worth it never know which way the grain will run.

I will try another method of dust removal with a a back up got covered in the inlet sounds like a V2 rocket engine but the way I turn initially with a fingernail gouge sends a lot to the lathe bed or me, in common with all of these timbers its a wrench on the breathing system all the Rosewoods are guilty.

I like this one.

Peter.

[QUOTE="Penpal, post: 42576, member: 122"] Found it difficult to buy cross cut but well worth it never know which way the grain will run. I will try another method of dust removal with a a back up got covered in the inlet sounds like a V2 rocket engine but the way I turn initially with a fingernail gouge sends a lot to the lathe bed or me, in common with all of these timbers its a wrench on the breathing system all the Rosewoods are guilty. I like this one. Peter.:thumbs: [/QUOTE]

Verification