• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Jim,

If you check out Clarkson Collet Chuck you may get the information you need on assembly and use.

I used to have it all but can't find any at the moment. I have a fair pile of end mills/slot drils up to 9/16" that are ideal for flat bottom holes :thumbs:


Top