• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Collets

Penpal

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
Several applications. 1.With my mandrel which came complete/ with collet to the headstock. 2. On each lathe part of a set for close holding cartridges etc. 3. On several routers. 4. On my milldrill. 5. On my three metal lathes.

Peter.
 
21William

21William

Fellow
Joined
Jan 21, 2016
Posts
1,629
Location
Dorset
First Name
William
On my recent Cigar Pen I used a collet (20mm) to accurately drill the blanks. I turned the blank between centres first then popped it into the collet for drilling. It worked out really well.
 
21William

21William

Fellow
Joined
Jan 21, 2016
Posts
1,629
Location
Dorset
First Name
William
The best type of collet chuck to get is one that screws directly onto the lathe spindle like this one as it allows work to pass right through the chuck:

SCT Wood Lathe Collet System

Sadly the only size I’ve seen recently is the 3/4 x 16 version. I’m sure other sizes used to be available?
 
Penpal

Penpal

Grand Master
Joined
May 26, 2013
Posts
25,342
Location
Canberra AUSTRALIA
First Name
Peter
21William said:
The best type of collet chuck to get is one that screws directly onto the lathe spindle like this one as it allows work to pass right through the chuck:

SCT Wood Lathe Collet System

Sadly the only size I’ve seen recently is the 3/4 x 16 version. I’m sure other sizes used to be available?
Click to expand...

Is this a lathe with a no1 morse taper inside the spindle, if so it chokes down the biggest collets?

Peter.
 
B

Bigblackdog

Registered
Joined
Dec 28, 2014
Posts
839
Location
Leeds
First Name
Mark
21William said:
The best type of collet chuck to get is one that screws directly onto the lathe spindle like this one as it allows work to pass right through the chuck:

SCT Wood Lathe Collet System

Sadly the only size I’ve seen recently is the 3/4 x 16 version. I’m sure other sizes used to be available?
Click to expand...

i have the beall one. Same principle but is available 1 x 8. It is a really nice bit of kit, but is more expensive. I bought a full set of collets from ebay which was good value and very useful.
 
21William

21William

Fellow
Joined
Jan 21, 2016
Posts
1,629
Location
Dorset
First Name
William
Penpal said:
Is this a lathe with a no1 morse taper inside the spindle, if so it chokes down the biggest collets?

Peter.
Click to expand...

I guess so. Number 1 morse is pretty small isn’t it.

My metalwork lathe is MT3 and the through bore is a useful 20mm which really suits the ER32 chuck I have for it.

Collet chucks are very useful, I have several ER32 types for both of my Lathes and Milling machine.
 
Warning! This thread has not had any replies for over a year. You are welcome to post a reply here, but it might be better to start a new thread (and maybe include a link to this one if you need to).
Top