• Thanks for visiting The Penturners Forum today.

    There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

    To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

If you sand your blanks to square them up then it is likely you will create a small burr on the inside of the brass tube plus what Woody says about the glue. I use a half round needle file to take the glue and burr off !!!!


Top