New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

Not got one but have heard various story's about the changing of gears one of which has been mentioned in that you need to make sure that you put it down into the slowest speed at the end of turning a piece. The adjustable speed pulley and shafts need to be kept clean. Following the above should see no problems with it.

[QUOTE="Dalboy, post: 160438, member: 449"] Not got one but have heard various story's about the changing of gears one of which has been mentioned in that you need to make sure that you put it down into the slowest speed at the end of turning a piece. The adjustable speed pulley and shafts need to be kept clean. Following the above should see no problems with it. [/QUOTE]

Verification