New posts

Thanks for visiting The Penturners Forum today.

There are many features and resources that currently you are unable to see or access, either because you're not yet registered, or if you're already registered, because you're not logged in.

To gain full access to the forum, please log in or register now. Registration is completely free, it only takes a few seconds, and you can join our well established community of like-minded pen makers.

Reply to thread

Message

I have a Charnwood version of that lathe, paid £40 for it if I remember right.
Woody picked it up for me as it was local to him, thanks dad, it was well worn when I got it, a new belt and bearings and never a problem since
I know I can switch it on now and it will do as much as any other lathe of it's size.

[QUOTE="Grump, post: 160630, member: 232"] I have a Charnwood version of that lathe, paid £40 for it if I remember right. Woody picked it up for me as it was local to him, thanks dad, it was well worn when I got it, a new belt and bearings and never a problem since I know I can switch it on now and it will do as much as any other lathe of it's size. [/QUOTE]

Verification